Ice Maker Not Working? Complete Troubleshooting Guide

Quick answer

When an ice maker is not working, check that it is switched on, the freezer is at 0°F or colder, the water valve is fully open and the filter is not clogged. Clear any clumped ice from the bucket, then run the ice maker test or reset it. Allow several hours for new ice before calling for service.

An empty ice bucket is one of the most common refrigerator complaints, and one of the most fixable. A refrigerator ice maker needs only three things to work: power to its motor, water at enough pressure, and a freezer cold enough to freeze that water quickly. When an ice maker is not working, one of those three is almost always missing, and you can find which one without tools.

This guide combines the official troubleshooting pages from Samsung, LG, Whirlpool and GE Appliances. The brands do not agree on everything, especially the freezer temperature, and we show where they differ. Our own tips are labeled as ours.

Why your ice maker is not working: 9 causes

Start at the top. The first five causes cost nothing and take minutes.

#CauseWhat you noticeDifficultyTypical cost
1Ice maker switched offNo ice at all; Ice Off light on, or the switch or arm is offEasy$0
2Freezer too warmSmall, slow or no cubes; soft ice creamEasy$0
3Bucket full, clumped or not seatedIce in the bin but none made; bucket looseEasy$0
4Water supply valve closed or line kinkedNo water in the tray; slow water dispenserEasy$0
5Clogged or badly installed water filterSlow dispenser, small cubes, filter light onEasyPrice of a filter
6Ice maker needs a resetWas working, then stopped after a power cut or filter changeEasy$0
7New refrigerator still cooling downInstalled within the last dayEasy$0 (wait)
8Low water pressure or reverse osmosis systemSmall, hollow cubes; weak dispenserMediumA plumber, if needed
9Failed part (ice maker motor, water inlet valve, frozen fill tube)Test does nothing, or water never reaches the trayHardRepair quote

If the freezer itself is warm, fix that first: no ice maker will work in a freezer that is not freezing. Our refrigerator not cooling guide covers vents, coils and settings.

Safety first

Keep your fingers out of the ice maker and the dispenser chute: the ejector arm and the auger can move without warning. Unplug the refrigerator before you pull it out or touch the water line. Samsung says not to use a hair dryer on a frozen ice maker or bucket and not to force a frozen bucket out. If water leaks onto the floor, turn off the supply valve and wipe it up to avoid a slip.

Fix 1: Make sure the ice maker is turned on

It sounds too simple, but it is one of the most common causes, especially after cleaning the freezer or after a child presses buttons on the panel.

  1. Look at the control panel. Samsung says the Ice Off icon should not be lit. Depending on the model, you turn it on with a button press, a press-and-hold, or in the SmartThings app.
  2. LG says some models have a power switch on the left side of the ice maker. If there is no switch, press and hold the Ice On/Ice Off button for 3 to 5 seconds until ICE ON lights.
  3. Older ice makers have a wire arm on the side. When the arm is up, the ice maker is off. Push it down to turn it on (our note; check your manual).
  4. LG says to allow 24 hours for ice production to begin after turning it on.

Fix 2: Check the freezer temperature

Ice makers need a colder freezer than most people expect. This is the point on which the brands differ most:

BrandFreezer setting for ice
Samsung0°F or lower
GE Appliances0°F recommended; a cycle does not start until the ice maker reaches 16°F
WhirlpoolBetween 0°F and 5°F
LG-4°F recommended minimum; must stay below 19°F

Why the difference? Each brand designs its ice maker and freezer airflow differently, so follow the number for your brand. If you do not know, 0°F works for most.

  1. Set the freezer to the value in the table.
  2. Samsung suggests turning on Power Freeze and checking again after 3 hours.
  3. GE says to keep the freezer about three-quarters full or more, because a nearly empty freezer has less stable temperatures.
  4. Use a freezer thermometer in the middle of a shelf for a true reading (our tip). The number on the display is a setting, not a measurement.

Fix 3: Empty and reseat the ice bucket

The ice maker stops when it thinks the bucket is full. A clump of old ice, a forgotten scoop or a bag of peas can fool it.

  1. Samsung says the bucket should contain only ice: scoops or food can make the ice maker think it is full.
  2. Remove the bucket and empty it. Break up any clumps.
  3. Samsung says that on fridge-compartment ice makers, the bucket must be fully seated and locked, and on freezer ice makers, the freezer door must close properly.
  4. Dispense or use ice regularly. Samsung says to dispense ice occasionally so it does not pile up.
  5. GE says a stuck ejector rake or cubes blocking the mold stop the ice maker from completing its cycle. Remove them carefully, since GE notes the mold may be hot.

If the bucket is frozen in place, do not pry it out. Samsung says the ice maker has automatic defrost, and if that is not working, it needs service.

Fix 4: Check the water supply

No water, no ice. This is the most likely cause when the tray is dry.

  1. Find the supply valve, usually under the kitchen sink, in the basement below the fridge, or behind the refrigerator.
  2. Whirlpool says to make sure the water line is securely connected and the valve is fully open.
  3. Unplug the refrigerator and pull it out. Whirlpool says to straighten any kinks in the line and not to push the refrigerator too far back, which can pinch it.
  4. If your fridge has a water dispenser, test it. Samsung says 6 ounces should fill in under 10 seconds on dispenser models. A slow dispenser points to the supply or the filter.

Whirlpool adds a warning worth knowing: an ice maker that is turned on but not connected to a water line can cause a buzzing noise and make the refrigerator too cold. If you do not use the ice maker, switch it off.

Fix 5: Check the water filter

A clogged filter slows water to a trickle. A filter that is not seated properly can stop it altogether.

  1. Test without the filter. Whirlpool and Samsung both describe removing the filter and trying the dispenser. If water flows well without it, the filter is the problem. Some models need a bypass plug to run without a filter; check your manual.
  2. Seat it properly. Whirlpool says a newly installed filter must be locked in place and sealed.
  3. Replace on schedule. Whirlpool says to replace the filter every 6 months, when the indicator light comes on, or as needed. GE says every 6 months, and more often if new construction has added sediment to your water.
  4. Use the right filter. Samsung, Whirlpool and GE each recommend their own brand of filter.

The idea is the same as in other appliances: a small filter that nobody checks causes a big symptom. Our dishwasher filter guide is a good example from the kitchen.

Fix 6: Reset or test the ice maker

Most modern ice makers have a test or reset function that forces one full cycle. It tells you whether the motor and the water valve work.

Samsung:

  1. Find the Test button on the ice maker (see your manual).
  2. Press and hold it until you hear a chime. Samsung says this can take up to 10 seconds.
  3. Water should pour into the tray at the end: about 6 minutes later for a fridge-compartment ice maker, or about 30 seconds for a freezer ice maker.
  4. No chime? Samsung says to power cycle the refrigerator for 2 minutes at the plug or breaker and try again. If there is still no chime, movement or sound, request service.

LG:

  1. Open the ice compartment, remove the bucket and put a towel underneath.
  2. Press and hold the test button for about 3 seconds until the ice maker starts to turn. Some models use a paper clip in a small hole.
  3. LG notes that on some models the test can run only once in the first two hours after plugging in.
  4. If the motor did not run or no water reached the tray, LG says the unit most likely needs service.
  5. LG’s reset: shake the ice maker gently up and down a couple of times, replace the bin, and turn the unit off for 30 seconds before turning it back on.

Whirlpool:

  1. Find the reset button (see your manual) and hold it for a few seconds.
  2. If there is no reset button, Whirlpool says to unplug the refrigerator for 1 minute, then plug it back in.

Fix 7: Give a new refrigerator time

A new refrigerator, or one that was just moved and switched back on, needs time to get cold enough. LG says a newly installed unit can take up to 24 hours for each compartment to reach temperature and for the ice maker to begin making ice. Throw away the first few batches of ice from a new installation or a new filter: they can carry loose carbon dust or air from the line (our advice).

Fix 8: Low water pressure and reverse osmosis systems

Samsung says the water pressure must be at least 20 psi. If you have a reverse osmosis (RO) filtration system under the sink, Samsung says to contact a plumber, because these systems can reduce the pressure the refrigerator needs.

Signs of low pressure: small or hollow cubes, a slow dispenser, and a tray that is only partly filled after the test.

Fix 9: When a part has failed

If the test runs but no water reaches the tray, the water inlet valve or a frozen fill tube is likely. If the test does nothing at all, the ice maker module or its control may have failed. Samsung says not to defrost the ice maker yourself and to request service if the automatic defrost is not working.

How long to wait before calling:

  • Samsung: request service if there is still no ice 3 hours after the reset. Normal output may take up to 24 hours.
  • LG: request a repair if it is still not making or harvesting ice after 4 to 6 hours.

Before you book, check your warranty. If the refrigerator is older and other problems are piling up, our repair or replace guide walks through the 50% rule.

Why does my ice maker make ice but not dispense it?

When the bucket is full but nothing comes out of the door, the ice maker is fine and the problem is the dispenser.

  1. Check that the control lock or child lock is off.
  2. Remove the bucket and break up clumps. Ice that sits for days fuses into a block the auger cannot move. Samsung says to dispense ice occasionally so it does not pile up.
  3. Make sure the bucket is pushed fully back; Samsung says fridge-compartment buckets must be seated and locked.
  4. Look into the chute for ice blocking it, and clear it with a plastic utensil, not a knife (our tip).
  5. If you hear the motor but nothing turns, or hear nothing at all, the dispenser needs service.

Why does my ice maker not fill with water?

If the tray stays dry after a test, work through the water path in order: the supply valve (Fix 4), the line behind the fridge, the filter (Fix 5), the pressure (Fix 8), and finally the inlet valve and the fill tube (Fix 9). A fridge that also leaks water inside may have a frozen or blocked tube; our refrigerator leaking water inside guide covers the drain and line problems.

How much ice should an ice maker make?

The pages we read do not give a daily output figure for full-size refrigerators. Samsung says normal production may take up to 24 hours to return after a reset, and LG says warmer freezer settings slow ice production. If your ice maker works but seems slow, set the freezer colder, keep the freezer well stocked as GE advises, and avoid opening the door often.

How to keep your ice maker working

  • Change the water filter about every 6 months (Whirlpool, GE).
  • Keep the freezer at your brand’s recommended temperature.
  • Use ice regularly and empty the bucket if you have not used it for a week or two (our tip).
  • Leave space behind the refrigerator so the water line is not pinched (Whirlpool).
  • Switch the ice maker off if it is not connected to water (Whirlpool).

When you change the water filter, write the date on the new one with a marker. Run about a gallon of water through the dispenser to clear air and loose carbon, and throw away the first batch of ice. Most “broken” ice makers after a filter change are just an air pocket or a filter not fully locked. This is our own routine.

Ice Maker Not Working? FAQ

How do I reset my ice maker?

On Samsung models, hold the Test button until it chimes, up to 10 seconds. On LG, hold the test button about 3 seconds, or switch the fridge off for 30 seconds. Whirlpool says to unplug the fridge for 1 minute if there is no reset button.

Why does my fridge dispense water but not make ice?

If the water dispenser works, the supply reaches the fridge. Check that the ice maker is on, the freezer is cold enough and the bucket is not full or clumped, then run the test. If water never reaches the tray, the inlet valve or fill tube may need service.

Does unplugging the fridge reset the ice maker?

Often, yes. Whirlpool says to unplug the refrigerator for 1 minute when there is no reset button. Samsung suggests a 2-minute power cycle if the Test button does not chime. LG uses 30 seconds.

How long does it take an ice maker to make ice again?

Samsung says to allow 3 hours for production to resume and up to 24 hours for normal output. LG says a new installation can take up to 24 hours before the ice maker starts making ice.

What temperature should my freezer be for ice?

It depends on the brand. Samsung says 0°F or lower, GE recommends 0°F, Whirlpool says 0 to 5°F, and LG recommends -4°F. Use your brand’s figure.

How often should I change the refrigerator water filter?

Whirlpool and GE say about every 6 months. Whirlpool adds: when the indicator light comes on, or sooner depending on use and water quality. GE says more often if new construction has added sediment.

Sources