Quick answer
A dryer drum not turning is often a door that is not fully latched, an overloaded drum or a Start button that was not held long enough. If those check out, turn the empty drum by hand: if it spins with no resistance, GE says the belt may be broken or loose.
A dryer drum not turning leaves you with wet clothes and one question: free fix or service call? One simple test, turning the empty drum by hand, narrows it down to the belt, idler pulley, rollers or motor. This guide follows LG, Samsung, Whirlpool and GE support pages and marks our own tips.
Why is my dryer drum not turning?
The first four rows cost nothing.
| # | Cause | What you notice | Who says so | Fix |
|---|---|---|---|---|
| 1 | Door not latched | Drum stops; LG electric models show dE | LG, Samsung | Close firmly, restart |
| 2 | Start not held | Timer never counts down | Whirlpool, Samsung | Hold Start 2 to 5 seconds |
| 3 | Child Lock on | Buttons do nothing | Samsung | Turn the lock off |
| 4 | Drum overloaded | Stalls or belt slips | LG, GE | Remove part of the load |
| 5 | Broken or loose belt | Drum spins freely by hand | GE | Replace the belt |
| 6 | Worn idler pulley | Squealed before it stopped | Whirlpool (wear) | Replace the pulley |
| 7 | Seized rollers | Drum hard to turn | Our tip | Replace the rollers |
| 8 | Failed motor | Hum or silence, belt intact | Our tip | Technician |
Safety first
Unplug the dryer before testing the drum by hand or removing any panel. On a gas dryer, close the gas valve before moving it; if you smell gas, leave and call your gas utility. Cabinet edges are sharp, so wear gloves. If the belt broke with a burning smell, do not run the dryer until it is checked.
Step 1: Rule out the door, load and controls
LG’s dryer drum not turning page says the drum stops for safety if the door opens mid-cycle, and that an overloaded drum may not rotate.
- Push the door shut until it latches, then press Start/Pause. On LG electric models this clears the dE (door error) code.
- Check the load. LG suggests a drum about half full.
- Hold Start. Whirlpool’s not tumbling or spinning page says to press and hold it for two to five seconds, with dry hands and a dry panel.
- Check the locks. Samsung’s dryer will not start or spin page says Child Lock stops the Start button working; switching off the breaker for 60 seconds also resets the controls.
Step 2: Run the empty-drum test
Take the clothes out and press Start/Pause. LG says that if the empty drum turns, the dryer is working normally; if not, it may need service.
Samsung adds a timer test: select Time Dry and hold Start. If the timer does not count down after one or two minutes, the cycle never started. If it counts down but the drum sits still, Samsung says to request service. Controls running with a stopped drum points to the drive parts below.
Whirlpool also notes electric dryers need a 240-volt supply. If the light works but nothing turns, check both halves of the breaker; our dryer won’t start guide explains how.
Step 3: Turn the drum by hand
Unplug the dryer, open the door and turn the drum.
- Spins freely, nothing attached. GE’s drum does not turn page says the belt may be broken or loose and service will be required.
- Grinds, scrapes or has tight spots. Usually worn rollers or a drum bearing (our tip).
- Barely moves. Look for an item jammed at the drum edge. Otherwise a seized roller is more likely than the motor (our tip).
- Feels normal. Belt and drum are probably fine; suspect the motor, a switch or the controls.
Belt, idler pulley or motor: how to tell them apart
The drive belt wraps around the drum and a small pulley on the motor shaft. The idler pulley is a spring-loaded wheel that keeps the belt tight. The motor turns the belt and, on most models, the blower fan.
Belt. GE says heavy, wet loads such as towels or blue jeans can make the drive belt slip, so an intact belt can still stall. A snapped belt gives the free-spinning drum from Step 3. Depending on the model, the motor may keep humming afterwards or not run at all (our note).
Idler pulley. Whirlpool says that as a dryer ages, the belt and pulleys wear, cause squealing and may need replacing. A squeal that grew for weeks and then stopped with the drum suggests the pulley let the belt go slack. Still turning but noisy? See our dryer squeaking guide.
Motor. Suspect it when the belt is intact, the drum turns smoothly by hand and the dryer only hums or stays silent. Rule out seized rollers first. Motor testing needs live-voltage checks, so call a technician.
Can you replace a dryer belt yourself?
Handy owners often do: remove the front or top panel, wrap the new belt around the drum and route it under the idler pulley. Order parts by the model number on the door tag. If the pulley or rollers are worn, replace them too. On a dryer under warranty, call the brand first.
Is it worth fixing?
A belt or idler pulley is usually a moderate job. HomeAdvisor’s dryer repair cost guide puts typical dryer repairs at roughly $100 to $430. The NAHB home component life study gives dryers about 13 years, so a younger dryer is usually worth saving. For older units or motor quotes, use the 50% rule in our repair or replace guide. Afterwards, a clean vent eases the strain; see our dryer vent cleaning guide.
Before calling a technician, note whether the drum spins freely, whether the motor hums and whether the timer counts down. Those answers help the right part arrive on the first visit. This tip is our own.
Dryer Drum Not Turning? FAQ
How do you fix a dryer drum that won’t turn?
Latch the door, reduce the load and hold Start for two to five seconds. If it still won’t turn, empty it and turn it by hand. A drum with no resistance usually needs a new belt, which GE says requires service.
Can I still use a dryer if the drum doesn’t spin?
We would not. Without tumbling, clothes sit in one place and dry unevenly; that is our own view. If the belt broke with a burning smell, keep the dryer unplugged until it is inspected.
Is a dryer drum supposed to spin freely?
No. GE says that if the drum turns freely, the belt may be broken or loose. A healthy drum turns by hand with some resistance.
How much does it cost to fix a dryer drum that won’t turn?
HomeAdvisor puts typical dryer repairs at roughly $100 to $430. A belt or idler pulley usually sits at the lower end; a motor or control board costs more.
Why does my dryer hum but the drum won’t turn?
Often a seized roller, a jammed item or a failing motor (our own view). Unplug it right away, because a stalled motor can overheat.
