Quick answer
A dryer squeaking for a second when the drum starts or reverses is often normal belt friction, LG says. A squeal throughout the cycle usually means an overloaded drum (Samsung) or worn belt, rollers, idler pulley or drum shaft (Whirlpool, LG). Reduce the load first; persistent metal-on-metal squealing needs a technician.
A dryer squeaking is one of those noises that starts small and gets louder each week. It can be harmless, or a part wearing through. When the noise happens tells you which, and most cases take fifteen minutes to sort. This guide follows LG, Samsung and Whirlpool’s support pages and keeps our own tips separate.
What causes a dryer to squeak or squeal
Work down this table from the top. The first three checks are free.
| # | Cause | When you hear it | Who says so | Fix |
|---|---|---|---|---|
| 1 | Belt friction at start-up or drum reversal | A short high pitch, then it stops | LG (normal) | Nothing to fix |
| 2 | Load too heavy | Squeal, squeak or grind during the cycle | Samsung | Stop, remove part of the load |
| 3 | Dryer not level or a foot missing | Rattle or squeak while tumbling | Whirlpool | Level the feet |
| 4 | Lint packed around the belt and pulleys | Squeal from inside the cabinet | Whirlpool | Inside cleaning, often a service call |
| 5 | Worn belt or idler pulley | Steady squeal that gets worse with age | Whirlpool, LG | Replace the worn part |
| 6 | Worn drum rollers | Squeal, sometimes with a thump each turn | LG | Replace the rollers |
| 7 | Loose drum shaft or hardened lubricant | Metal-on-metal scraping, the whole cycle | LG | Service appointment |
Safety first
Unplug the dryer before you pull it out, tilt it or look behind it. On a gas dryer, turn off the gas valve before you move it and do not kink the gas line; if you smell gas, leave the house and call your gas utility. Do not spray WD-40 or other household oils inside a dryer: it runs hot, and lint and oil are both flammable. That warning is our own.
Step 1: Decide whether the noise is normal
LG explains on its noise from the dryer page that a high-pitched sound at start-up, or when the drum changes direction, comes from friction as the belt that connects the drum and the motor tightens. LG says this does not indicate a malfunction and may last briefly.
- Run an empty, timed cycle and listen for the first minute.
- A squeak that lasts a second or two and fades is the belt settling; models that reverse the drum repeat it at each reversal.
- If it continues once the drum turns steadily, move to Step 2.
Step 2: Check the load
Samsung’s dryer is too noisy page says squealing, squeaking or grinding usually means the load is too heavy. Its advice:
- Stop the cycle as soon as you hear the noise.
- Take out part of the load and restart. Dry fewer items at a time.
- Run an extra spin in the washer first, so the clothes carry less water into the dryer.
- If the noise continues with a normal load, about four wet towels, Samsung says to request service.
Empty pockets as well. Whirlpool’s squealing or squeaking page lists loose coins, paper clips and pens tumbling in the drum among the noise sources.
Step 3: Level the dryer
Whirlpool says a dryer that is not level, or that is missing a leg, can make a rattling noise, and suggests checking it with a level or a phone level app.
- Unplug the dryer and pull it out a few inches.
- Put a level across the top, side to side and front to back.
- Adjust each foot until the bubble is centered. Press each corner: it should not rock.
Uneven floors and loose feet also cause noise in washers; our washer shaking violently guide covers the same leveling method in more detail.
Step 4: Listen for where the squeal comes from
If the squeal survives the first three steps, it is almost always mechanical. The tips below are our own diagnostic habits, not brand instructions:
- Turn the drum by hand with the dryer unplugged and the door open. A squeak you can hear while turning it by hand points to the rollers, the drum bearing or the shaft.
- Squeal only with the motor running points more to the idler pulley or the belt.
- Squeal plus a thump once per drum turn often means a roller with a flat spot.
- Squeal plus a burnt-rubber smell points to a slipping belt. Stop using the dryer until it is checked.
Step 5: Worn belt, idler pulley or rollers
Whirlpool says that as a dryer ages, the belt and pulleys can wear and cause squealing sounds, and these components may need to be replaced. It also says lint built up inside the dryer can make the belt and pulleys squeal, and that removing it may require a service call to take off the back panel. LG lists worn rollers or a worn belt, a loose drum shaft and hardened lubricant as causes of a squealing or screeching sound “like metal scraping.”
The belt wraps around the drum and turns it; the idler pulley is a small wheel that keeps the belt tight; the rollers carry the drum’s weight.
Replacing these parts means taking the cabinet apart. If you are handy, order parts by your full model number. Otherwise, LG and Samsung both say to schedule service when the noise persists.
Is a squeaking dryer dangerous?
A squeak alone is a wear sign, not an emergency. Stop using the dryer if the squeal comes with a burning smell, or with damp clothes and a very hot cabinet. If drying time has crept up along with the noise, clean the vent too, and work through our dryer taking too long to dry guide. If the drum turns but the air is cold, see our dryer not heating guide.
Repair or live with it?
A belt, idler pulley or set of rollers is usually a moderate repair compared with a motor or a control board. On an older dryer, compare the quote with the price of a comparable new one using the 50% rule in our repair or replace guide. If the dryer is still under warranty, call the brand before you open anything.
When a technician is coming, record ten seconds of the noise on your phone at the start of the cycle and again after five minutes. Intermittent squeaks often stop when someone arrives. This is our own tip.
Dryer Squeaking or Squealing? FAQ
Why does my dryer squeak only when it starts?
LG says a short high-pitched sound at start-up or when the drum reverses comes from the belt tightening and does not indicate a malfunction. If it fades after a moment, you can leave it.
Why does my dryer squeal with a full load?
Samsung says squealing, squeaking or grinding usually means the load is too heavy. Stop the cycle, remove part of the load and spin the clothes again in the washer to remove water.
Can I lubricate a squeaky dryer myself?
None of the brand pages we read tell owners to oil the drum. LG lists hardened lubricant as a service issue. Do not spray household oils inside a dryer; ask a technician which lubricant your model uses.
Can lint cause a dryer to squeak?
Yes. Whirlpool says lint buildup inside the dryer can make the belt and pulleys squeal and squeak. Cleaning it out may require a service call to remove the back panel.
How long can I run a squealing dryer?
There is no official limit. A worn belt or pulley can fail and stop the drum. Stop at once if you smell burning rubber, and book a repair if the squeal is constant.
