Quick answer
A Bosch dishwasher E15 error means a safety switch has found water in the base and the leakage protection system has switched on. Bosch says to turn off the water supply and call Bosch Customer Support. Before that call, you can safely check the hoses, the door seal and the detergent.
The Bosch dishwasher E15 error is not about a clog. It means water has escaped from the tub into the tray under it, where a safety switch sits. Once that switch trips, the dishwasher stops to protect your floor. Here is what Bosch says, which checks are safe, and when to call a technician.
What does E15 mean on a Bosch dishwasher?
Bosch’s E15 support page gives a short answer. An E15 indicates that “the safety switch has detected water in the base of the dishwasher” and that the leakage protection system has activated. Its only instruction is to turn off the water inflow and call Bosch Customer Support at 1-800-944-2904.
Bosch’s UK and Singapore pages for the same code add two checks: look around the base for leaks and check the hoses for kinks or damage. If the fault is not visible, they recommend a Bosch engineer.
Nearby codes on the Bosch US error code list are easy to confuse with E15:
| Code | What Bosch says it means | First check |
|---|---|---|
| E14 | Flow meter failure or a problem with water flowing in | Call Bosch support |
| E15 | Water in the base; leakage protection activated | Turn off the water, look for the leak |
| E16 / E17 | Problem with water flowing in or the fill system | Inlet hose not kinked or damaged |
| E24 | Not draining properly; drain filter blocked | Filter and drain hose |
Seeing E24 instead? Our Bosch E24 drain error guide covers that.
Why is there water in the base?
Bosch does not publish a list of E15 causes for US models. The table shows who says what.
| # | Possible cause | Who says so | Difficulty |
|---|---|---|---|
| 1 | Kinked or damaged hose | Bosch UK and Singapore | Easy–Medium |
| 2 | Damaged door seal | Bosch UK (leaking page) | Easy |
| 3 | Damaged spray arm or loose pump outlet connection | Bosch UK (leaking page) | Medium |
| 4 | Too many suds from dish soap | Samsung (general leak advice) | Easy |
| 5 | Water splashed near the sensor after a move | Samsung (general leak advice) | Easy |
| 6 | Cracked tub, failed seal on the pump or a leaking inlet valve | Our own addition | Hard |
The last row is why Bosch sends US owners to a technician: those leaks sit under the tub, behind panels.
Safety first
Switch the dishwasher off at the circuit breaker and close the water supply valve under the sink before any check. Do not remove the base pan yourself; Bosch’s regional pages say not to attempt repairs when the fault is not visible.
How do I clear a Bosch E15 error?
Steps 1 and 2 follow Bosch. The rest are safe checks without panel removal.
Step 1: Turn off the water and the power
- Close the hot water valve that feeds the dishwasher, usually under the kitchen sink. Bosch’s first instruction for E15 is to turn off the water inflow.
- Switch off the dishwasher’s circuit breaker.
- Put towels on the floor in front of the dishwasher.
Step 2: Look around the base and the hoses
- Unclip the kick panel at the bottom front, or look in from the sink cabinet.
- Check around the base for water, as Bosch’s UK and Singapore pages suggest.
- Follow the inlet and drain hoses. Look for kinks, cracks or a wet fitting.
- If a hose is visibly damaged, Bosch says to order a replacement hose as a spare part.
Step 3: Inspect the door seal and spray arm
- Open the door wide and look at the door seal for tears or missing pieces. The Bosch UK leaking page lists a damaged seal as a cause.
- Pull out the lower rack and turn the lower spray arm by hand. Bosch says a damaged arm can spray water toward the door seal.
- If the arm turns freely, Bosch says to remove it as your manual shows and make sure the tube connection on the pump’s water outlet is tight.
Step 4: Rule out suds
The Samsung leakage page says dish soap “will create excessive amounts of suds” that can escape and cause leaks, which applies to any brand. If you see foam in the tub, wipe it out and use only dishwasher detergent.
Step 5: Let the base dry, then reset
Samsung says its leak sensor stays tripped until the moisture is gone. Bosch gives no drying time for E15. Our own approach: leave the breaker off for a full day with the kick panel open.
Then use the general reset from Bosch’s error code page:
- Turn the power back on at the breaker.
- Turn the dishwasher on, wait about a minute, and check the display.
- Open the water valve and run a short test cycle with no dishes. Stay nearby.
If E15 returns, stop. Turn off the water again and call Bosch.
Should you tilt the dishwasher to drain the base?
Many videos show people tipping a Bosch backward to empty the base pan. Bosch does not describe this. A built-in dishwasher is screwed to the counter and connected to water, drain and power, so tilting it means partly uninstalling it. Our advice: let it dry in place and call Bosch if the code persists. The base fills again anyway if the leak is not fixed.
When does E15 need a technician?
Call Bosch Customer Support at 1-800-944-2904 when:
- The code returns after drying and a reset.
- You find water in the base but no damaged hose, seal or spray arm.
- Water appears under the dishwasher during every cycle.
A recurring E15 usually points to a hidden leak that needs the base opened. If the dishwasher is old and out of warranty, compare the quote with the 50% rule in our repair or replace guide.
If water only shows up at the front, see our guide to a dishwasher leaking from the door. For standing water inside the tub, start with the dishwasher not draining troubleshooting steps. For washers, see our washer leaking from the bottom guide.
Once a year, pull the kick panel and shine a flashlight underneath during a cycle. A drip at a fitting is cheap to fix before it triggers E15. This is our own habit.
Bosch E15 Error? FAQ
Can I reset a Bosch E15 error myself?
You can cut power at the breaker, wait, and turn it back on. But the code returns until the base dries and the leak is fixed. Bosch advises turning off the water and calling support.
Is it safe to use my Bosch dishwasher with an E15 code?
No. Bosch’s leak protection has detected water in the base. Turn off the water supply and do not run cycles until the leak is found.
How long does it take for the base to dry?
Bosch gives no drying time. Samsung says its leak sensor stays active until the moisture is gone. A day with the breaker off is our own rule of thumb.
Can dish soap cause an E15 error?
Bosch does not mention soap for E15. Samsung says dish soap creates excess suds that can escape and cause leaks. Use only dishwasher detergent.
What is the difference between E15 and E24 on a Bosch?
Bosch says E15 means water is in the base and the leakage protection is active. E24 means the dishwasher is not draining properly, usually because the drain filter is blocked.
