Samsung Washer 5C Error (Drain Error): How to Fix It

Quick answer

A 5C error means your Samsung washer can’t pump water out fast enough, or at all. Most of the time the fix is free: straighten the drain hose, check how it sits in the standpipe and, on front-loaders, clean the drain pump filter. Expect 15–30 minutes.

Depending on the model, the same fault shows as 5E, SE, nd or SC. Samsung treats them all as one “No Drain” error. If your washer shows OE or 0E (too much water in the tub), start with the same checks.

This guide follows Samsung’s U.S. guide for a washer that won’t drain. It’s part of our full Samsung washer error codes list. For other brands or a general drain problem, see our washer not draining guide; LG’s version of this code is in our LG OE error guide.

What causes a 5C error on a Samsung washer

Check the causes in this order. The first four cost nothing.

Check orderCauseApplies toDifficultyCost
1Drain hose kinked, crushed or pushed too far into the standpipeAll modelsEasy$0
2Drain hose set too low or too high, or sealed airtight in the drainAll modelsEasy$0
3Washer not levelAll modelsEasy$0
4Clogged drain pump filter (coins, hair ties, lint)Front-load onlyEasy–Medium$0
5Clog in the house drain or standpipeAll modelsMedium$0 to snake it yourself; otherwise a plumber
6Blocked or failed drain pumpAll modelsHard$300–$400 pro repair
7Control board or sensor faultAll modelsHardVaries: get a quote

Repair costs come from HomeAdvisor’s washing machine repair guide (updated June 17, 2026) and are national averages for all brands.

Safety first

Unplug the washer before you touch the drain hose or open the filter door. A washer that stopped on 5C is often still full of water, so put towels down and have a shallow pan or bucket ready before you open anything. Never run a cycle with the pump filter removed.

How to fix a Samsung 5C error

Run a Drain/Spin cycle after each fix. If the tub empties, you’re done and can skip the rest.

Fix 1: Check the drain hose (5 minutes)

  1. Pull the washer out a little and follow the drain hose along its whole length. Straighten any kink and make sure the washer isn’t pressing on it.
  2. Check how deep the hose goes into the standpipe or sink. Samsung says it should be inserted no less than 6 inches and no more than 8 inches.
  3. Check the height of the hose end. It should be at least 18 inches high (24 inches for a wash basin) and no higher than 96 inches (35 inches for a basin).
  4. Make sure the hose doesn’t form an airtight seal in the drain, and don’t use a drain hose extension kit. Samsung lists both as causes of drain problems.
  5. Leave the screw that holds the drain hose on the back of the washer in place. Samsung says not to remove it.

Fix 2: Level the washer (5 minutes)

Samsung lists an unlevel washer as a cause of drain problems. Check that all four feet touch the floor and the cabinet doesn’t rock. Turn each leveling foot to raise or lower that corner, and check with a level if you have one.

Fix 3: Clean the drain pump filter (front-load only, 15–20 minutes)

Tools: towels, shallow pan, coin, bucket.

  1. Unplug the washer. Find the small access door at the lower front and open it with a coin.
  2. Lay towels down and set the shallow pan under the door.
  3. Pull out the emergency drain hose, remove its cap and let the water run into the pan. Recap it whenever you need to empty the pan.
  4. When the water stops, turn the filter counterclockwise and pull it out. A little more water will come out.
  5. Remove any debris, rinse the filter in warm water and wipe the opening with a damp cloth.
  6. Screw the filter back in clockwise until it’s snug, recap the emergency hose and close the door.

Samsung’s U.S. guide notes that top-load washers don’t have a removable pump filter, so skip this fix on a top-loader. The filter steps follow Samsung’s guide to the 5E and 5C error.

Fix 4: Rule out a clogged house drain (10 minutes)

  1. Take the drain hose out of the standpipe and check the end for lint or a stuck sock. Clear anything you find.
  2. Pour a bucket of water, or run a sink hose, into the standpipe. If it drains slowly or backs up, the clog is in your house drain, not the washer.
  3. Clear the house drain with a drain snake, or call a plumber, then put the hose back 6–8 inches into the standpipe.

Fix 5: Run a drain test (2 minutes)

Plug the washer back in, choose a spin-only or Drain/Spin cycle and start it. Listen during the drain. A steady hum with no water moving, or no pump sound at all, points to a blocked or failed drain pump. That’s a job for a technician.

How to prevent 5C errors

Most drain errors start with small things that end up in the pump. A few habits keep them away:

  • Empty pockets before every wash. Coins, keys and hair ties are what usually block the pump filter.
  • Wash socks, bras and other small items in a mesh laundry bag.
  • On a front-loader, check the drain pump filter every few months, and right away if draining starts to slow.
  • Leave the drain hose where it is once it’s set up correctly. Pushing the washer back can kink it.
  • Use the right amount of detergent. Too much creates suds that slow the drain.

When to call a technician for a 5C error

Call Samsung support or a local pro if 5C comes back after all five fixes, if the pump hums without draining, or if water leaks from under the washer.

HomeAdvisor puts a drain pump replacement at $300–$400 and the average washing machine repair at $125–$450 (updated June 17, 2026). Check whether the washer is still under warranty, and have your model number ready.

If the washer is old and the quote is high, our repair or replace guides help you decide.

Samsung 5C error FAQ

What does 5C mean on a Samsung washer?

It means the washer can’t drain water correctly, or at all. Samsung groups 5C with 5E, SE, nd and SC as the same “No Drain” error.

Is 5C the same as 5E?

Yes. Samsung gives 5C, 5E, SE, nd and SC the same meaning. The code you see depends on the model and the year.

Do Samsung top-load washers have a drain filter?

No. Samsung says top-load washers don’t have a removable pump filter. On a top-loader, focus on the drain hose, leveling and your house drain.

How do I drain a Samsung washer that’s full of water?

On a front-loader, use the emergency drain hose behind the filter door at the bottom front, with towels and a shallow pan underneath. On a top-loader, unplug the washer and lower the end of the drain hose into a bucket on the floor so the water drains out.

Can a clogged house drain cause a 5C error?

Yes. If your standpipe drains slowly or backs up when you pour water into it, the washer can’t push water out fast enough. Clear the house drain first, then test the washer again.

Sources