How to Clean a Front Load Washer (and Kill the Smell for Good)

Quick answer

Front load washer smells? Moisture, soap residue and lint trapped in the door seal, the detergent drawer, the pump filter and the drum cause it. Wipe the seal, clean the drawer and the filter, run the tub clean cycle monthly, and leave the door open between loads.

A front load washer is good at saving water, and that is exactly why it can smell. The door seal holds a ring of water, the drum rarely dries on its own, and the detergent you do not rinse out becomes a film that mildew loves. The fix is not a miracle product. It is a short routine that removes the film and lets the machine dry.

This guide follows the cleaning pages from Samsung, LG and Whirlpool. The three brands agree on the routine, and where they differ on cleaners we say so. If the washer also leaks or drains slowly, our guides to a washer leaking from the bottom and a washer not draining cover those problems.

What makes a front load washer smell

Work down this list in order. All of the first six steps cost nothing but time.

Check orderCauseDifficultyCost
1Wet door seal and a door that stays closedEasy$0
2Wet clothes left in the drum after the cycleEasy$0
3Dirty detergent drawerEasy$0
4Dirty or clogged pump filterEasy–Medium$0
5Residue in the drum that a normal wash does not reachEasyA cleaner tablet or bleach, low cost
6Too much detergent, or detergent that does not dissolveEasy$0
7An odor that survives several cleaningsHardService call

Whirlpool lists the causes the same way: residue that builds up between loads, leftover moisture, wet clothing left in the washer, the wrong detergent or too much of it, and a dirty dispenser drawer.

6 steps to clean a front load washer

Safety first

Unplug the washer before you open the pump filter panel. Never run a tub cleaning cycle with laundry in the drum, and never mix bleach with vinegar or any other cleaner. If you use bleach, keep the room ventilated and keep it out of reach of children and pets.

Step 1: Dry out the door seal and keep the door open (5 minutes, then every day)

  1. Pull back the rubber seal and look underneath. LG says hair, lint and detergent collect there, and that debris can leave gaps that hold water.
  2. Wipe the seal and the glass with a damp cloth. LG says to wipe the gasket with an oxygen-based bleach and then leave the door open to dry.
  3. For a stubborn film, the mix LG gives on its leak page is 3/4 cup of bleach or vinegar in 1 gallon of water. LG warns never to use straight bleach on the seal because it can make the gasket deteriorate.
  4. Leave the door open between loads. Whirlpool recommends it, and Samsung says to leave both the door and the detergent drawer open between uses so moisture does not linger.
  5. Take the clothes out promptly. Whirlpool says wet clothing left in the washer causes mildew, which creates odors in the clothes and in the washer.

Step 2: Clean the detergent drawer (10 minutes)

  1. On a Samsung front loader, push in on both ends of the drawer at the same time and pull it out. Other brands differ, so check your manual.
  2. Remove the inserts and rinse everything in warm water. Samsung says to use a soft brush if needed.
  3. Clean the opening where the drawer slides in with a soft cloth or a non-metallic brush. Samsung says to wipe the drawer dry after every wash session and to deep clean it at least monthly.
  4. Put the inserts back, line up the drawer with its rails and push it closed.
  5. LG explains why this matters: cold water may not fully dissolve detergent, which can cause buildup or odor, and the dispenser is where it collects.

Step 3: Clean the pump filter (15 minutes, once a month)

Tools: towel, a large shallow container, a soft toothbrush.

A clogged pump filter holds water in the machine, and Samsung says it can cause odors.

  1. Wait for a hot cycle to cool. Samsung says that after a Self Clean, Pure Cycle or Sanitize cycle the water will be very hot, so wait one hour before you drain the filter.
  2. Open the access panel near the bottom front of the washer. Samsung says to press its top or center.
  3. Put a towel and a large container under the small drain hose, twist off its cap and let the water drain.
  4. Turn the filter counterclockwise to remove it. On some models, Samsung says to push it in and twist.
  5. Clean it with a soft toothbrush and check that the drain pump impeller is clear.
  6. Put the filter back and turn it clockwise until it is secure. Press the hose cap back on firmly, clip the hose into place and close the panel.

Samsung says to clean the filter at least once a month or about every 40 washes, whichever comes first. Our guide to a washer leaking from the bottom shows the same filter from the leak side.

Step 4: Run the tub clean cycle (once a month)

This cycle cleans the parts of the drum that a normal wash does not reach. The brands name it differently and they differ on what to put in.

  1. Samsung: Make sure the drum is empty, press Self Clean, then press Start. Samsung says the cycle takes about four hours on a front loader and that you do not need to add cleaner for a routine run. Run it at least once a month, or sooner if you do not do many washes. A reminder light appears after 40 washes.
  2. LG: Run a tub clean cycle with a tub cleaner to break up detergent residue. LG recommends it once a month to prevent odor and buildup.
  3. Whirlpool: Run the Clean Washer cycle every month with affresh washer cleaner, liquid chlorine bleach or another washing machine cleaner. Whirlpool says not to use thickened, easy-pour or no-splash bleach with the affresh cycle, because it can cause excess suds. Follow the product label for where to put the cleaner and how much.
  4. If Samsung leaves suds or residue in the tub, run another Self Clean.
  5. When the cycle ends, wipe the drum and the seal, and leave the door open to dry. Whirlpool says to leave the door open slightly after the cycle for better ventilation.

Step 5: Remove an existing mildew smell (3–5 hours)

If the washer already smells musty or you can see mold, use the deeper routine. This is Samsung’s procedure for a mildew smell or visible mold.

  1. Make sure the drum is empty, then run a Spin-only cycle to remove any leftover water.
  2. Pour liquid chlorine bleach into the detergent compartment, up to the max line. Samsung says not to use the bleach compartment for this.
  3. Start the Self Clean cycle right away. Do not let the bleach sit in the washer.
  4. When it finishes, wipe out the residue with paper towels, then run a Rinse+Spin cycle. Repeat until you no longer see mold residue.
  5. Leave the door and the detergent drawer open to dry, and clean the pump filter.
  6. If the smell or the mold persists after several attempts, Samsung says to contact its Support Center. LG says that if the odor continues after multiple tub cleans, service is required.

Step 6: Use the right amount of detergent (every wash)

  1. Use only HE detergent, in the amount the manufacturer recommends. Whirlpool says non-HE detergent or too much detergent can cause excessive suds, leaks, draining problems or poor rinsing.
  2. LG says to reduce the amount you use whenever suds remain after a wash. On its leak page, LG says you often need just one or two tablespoons.
  3. If you usually wash in cold water, Samsung says to run a warm or hot cycle occasionally to slow soil and detergent buildup.

Cleaning the outside of the washer

A clean drum is the priority, but the door and the cabinet pick up grime too. Samsung says to use a mild detergent on a damp microfiber cloth, scrub in circles, rinse with a clean damp cloth and dry. For stubborn spots it suggests a small amount of Cerama Bryte. It also says to clean up spills right away to prevent blemishes on the door. Skip harsh or abrasive cleaners on the finish.

If your washer has a steam option

Whirlpool says that on steam models the steamer runs during the first 20 minutes of the cleaning cycle, and the drum does not spin or fill with water during that time. Condensation on the door window is normal. An affresh tablet may not fully dissolve during this phase, so do not panic if you still see part of it. After the cycle, leave the door open slightly so the inside can dry.

What you need

You do not need much, and most of it is already in the house.

  • A soft cloth and a soft brush or an old toothbrush
  • A towel and a shallow container for the pump filter
  • Your washer’s own cleaning cycle, plus the cleaner your manual names, such as a tub cleaner, affresh or liquid chlorine bleach
  • Paper towels for wiping the drum after a mildew treatment
  • HE detergent, measured to your manual’s amount

Keep your owner’s manual nearby, because the drawer, the filter panel and the cleaning cycle differ by model.

The monthly routine at a glance

If you want a single schedule, this covers what the three brands recommend.

How oftenWhat to do
After every loadTake clothes out promptly, leave the door and drawer open
Every washUse HE detergent in the recommended amount
Every week or soWipe the door seal and glass
Every monthRun the tub clean cycle, deep clean the drawer, clean the pump filter
Every 40 washesClean the pump filter, as Samsung recommends
When a smell appearsFollow Step 5 and repeat until it is gone

Most washers make this easy by reminding you. Samsung’s reminder light comes on after 40 washes.

Which cleaner should you use?

The brands do not agree, so use what your manual says.

  • Samsung says you do not need to add cleaner to a routine Self Clean. It recommends bleach only when you already have a mold smell, and never in a routine cycle.
  • LG says to run the tub clean cycle with a tub cleaner. For the gasket, its pages mention oxygen-based bleach, and its leak page gives the bleach or vinegar mix and the warning about straight bleach.
  • Whirlpool says affresh washer cleaner, liquid chlorine bleach or another washing machine cleaner works for the Clean Washer cycle, and warns about thickened bleach.

None of the three tell you to mix products, and bleach must never be combined with vinegar or other cleaners.

What not to do

  • Do not run a cleaning cycle with laundry inside. Samsung says it can damage the washer and its contents.
  • Do not put bleach in the bleach compartment for the mildew procedure. Samsung says to use the detergent compartment.
  • Do not leave bleach sitting in the washer. Samsung says to start the cycle right away.
  • Do not add bleach to a routine Self Clean on a Samsung.
  • Do not use straight bleach on the gasket. LG warns it can make it deteriorate.
  • Do not skip the pump filter. A dirty filter can cause odors, and Samsung says to clean it when you chase a smell.
  • Do not use thickened or no-splash bleach with affresh, as Whirlpool says.

Why it keeps coming back

If the smell returns a few days after a deep clean, one of the habits is missing.

  • The door is closing the washer up. Moisture has nowhere to go. Leave it open.
  • Wet clothes sit in the drum. Whirlpool says to remove them promptly.
  • Too much detergent. Extra detergent leaves a film that feeds the smell.
  • Cold-water washes only. Samsung suggests an occasional warm or hot wash.
  • A drain problem. A clogged filter or a slow drain leaves water in the machine. See our guide to a washer not draining.

When to call a technician for a smell that will not go away

Call the manufacturer or a local pro if the smell survives several tub cleans, if you find mold you cannot reach, or if the washer leaks or drains poorly. LG says that if odor continues after multiple tub cleans, service is required. Samsung says to contact its Support Center after several attempts.

HomeAdvisor puts the average washing machine repair at $125–$450 (updated June 17, 2026), but a smell by itself is rarely a repair. Before you book, check the warranty and tell the technician what you already tried.

If the washer is old and the quote is high, our repair or replace guide can help you decide.

Front Load Washer Cleaning FAQ

How often should I clean a front load washer?

Run the tub clean cycle at least once a month. Samsung says its reminder light comes on after 40 washes, and Whirlpool and LG both recommend monthly. Wipe the door seal more often and clean the pump filter monthly.

Why does my front load washer smell like mildew?

Moisture and soap residue collect in the rubber seal, the drawer, the filter and the drum. Whirlpool lists leftover moisture, residue build-up, wet clothes left in the washer, too much detergent and a dirty dispenser as the usual causes.

Can I use bleach to clean my washer?

Brands differ. Samsung uses liquid chlorine bleach only for an existing mildew smell, and in the detergent compartment. Whirlpool lists liquid chlorine bleach as an option for its Clean Washer cycle. LG warns not to use straight bleach on the gasket. Check your manual first.

Should I leave the washer door open?

Yes. Whirlpool says to leave it open between loads, and Samsung says to leave the door and the detergent drawer open between uses.

What if the smell comes back after cleaning?

Check the pump filter, the detergent amount and the door habit, then repeat the mildew procedure. LG says that if the odor continues after multiple tub cleans, you need service.

Is a washer smell a sign it needs repair?

Usually not. Most smells are residue and moisture. A smell that survives several deep cleans, or that comes with leaks or draining problems, is worth a technician’s look.

Sources